Command Tips
1 Mouse over the component symbol and press "q", or double-click on it to display the component properties dialog.
2 Mouse over symbols that are attached to schematics and press "d" or ctrl-double-click on it, to descend into/open up its schematic.
3 Resize the graph area by grabbing it's lower right corner.
4 Delete graph by clicking on the top horizontal rectangular outlined section of the graph, then press the delete key.
5 Delete a waveform by locking the cursor on its signal trace and press the delete key.
6 Press "a" (auto-scale) or the green "A" toolbar button to zoom the graph to full scale of the signals.
7 Drag the left mouse button to zoom in on waveforms.
8 Double click on waveform graph to set the graph up.
9 Shift click on waveform to reset/swap axis labels.
10 Alt click on wire or pin to display signal.
11 Shift click on wire or pin to un-display the signal.
12 Shift click on waveform to select that signal for axis labels.
13 Ctrl click on waveform to swap cursor.
14 Double click on waveform and OK to reset labels.
15 ESC, when component are selected, resets the schematic state and redraws the screen.
16 Clicking on pin starts drawing a wire.
17 Clicking on another pin or mid point of a wire will end the drawing of the current wire.
18 Double clicking will end drawing of the wire when the endpoint is not on a pin or wire midpoint.
19 Double-click on, or drag, a model or symbol name in the docked model/symbol folder tree to place components.