DC operating voltages and currents may be displayed on the schematic, or alternately, in the main window status bar when the mouse pointer is over a symbol, label or pin. For this feature to operate, calculation of operating point (blue "OP" button) must be enabled.
Floating Labels
DC operating points can be displayed using the floating labels feature. This displays the dc voltages and currents right at the node location. To enable this feature, double-click on a blank section of the schematic and tab to the Draw Options.
Display Device Operating Points
Check the "Display Device Operating Points" to enable display on the schematic of operating points such as gm, gds, vgst, gds when the mouse is moved over a component. Schematic Floating Labels should be enabled for this feature as there is typically too much data to be displayed in the bottom status bar.
Digital Issues
For mixed XSpice digital and analog schematics, operating points may cause problems on some transient runs and therefore may have to be disabled.